STEP 1: ASSEMBLE THE BASE

AFTER YOU HAVE PRINTED / RECIEVED YOUR PARTS, GLUE THE THREE SUPPORTS INTO THE BASE

STEP 2: ADD SUPPORT RINGS

ADD THE SUPPORT RINGS ON THE POLES TO SUPPORT THE TOP EVENLY. YOU SHOULD MAKE IT ABOUT 1MM UNDER THE HEIGHTH OF THE BASE EITH THE DICE IN IT. YOU SHOULD BE ABLE TO PUSH DOWN ON THE TOP WITHOUT IT WOBBLING

STEP 3: PREP SANDING TONGUE

I USE A 1200 GRIT ADHESIVE BACKED SANDPAPER USED FOR AUTO BODY REPAIR TO START, THEN USE THE ZONA PAPERS.

FOR ZONA , FEED BOTH ENDS THROUGH THE HOLES AND TAPE DON AT THE TOP. YOU SHOULD HAVE AT LEAST THE FIRST HALF OF THE HOLES COVERED ON THE BOTTOM

STEP 3: CONSTRUCT JIG

PUT THE TONGUE IN THE SLOT, LOWER THE TOP ON THE DICE.

YOU WILL NEED TO HOLD THE TOP OF JIG (NOT A LOT OF PRESSURE HERE) TO KEEPO IUT LEVEL ON THE DICE TO SECURE THE JIG

STEP 4: SAND AWAY

NOW THAT YOU GOT A GOOD GRIP JUST ROTATE THE BASE, AND PULL THE TONGUE IN AND OUT.
IF YOU ARE HOLDING IT STEADY, AND HAVE THE SUPPORT RINGS TO THE RIGHT HEIGHT IT SHOULD STAY LEVEL AND SAND PERFECTLY FLAT WITH THE SURFACE.

SAND ALL SIDES, I TYPICALLY DO ABOUT 30 SECONDS PER SIDE AND CHECK BYT LOOKING THROUGH IT AT THE LIGHT.

TRANSPARENT MASTERS WORKS BEST TOP ENSURE EVEN SANDING.